2000 WATT 11 BLADE WIND TURBINE

!NEW!! This is our 2000 watts 11 blade wind tourbine . Our most powerful wind turbine for home or business use. 


Our unrivaled blades self regulate their speed in high winds. - No slip rings to fail or replace. Simple and effective, the turbine uses a wire tension system which will last a lifetime. The single power transmission cord never twists because the wind never spins the turbine around in the same direction hundreds of times. Typically, the wind only comes from two directions. It has yet to be an issue with any one of the thousands of turbines we have distributed. 

Uses: Battery or battery bank charging, battery based and stackable wind turbine grid tie inverters, direct DC water heating elements, direct DC resistive heating, or other applications where 3 phase AC or DC can be used. (Cannot be plugged directly into a house outlet or other power source without the proper grid tie inverter) 

3 phase output is the most efficient , no voltage and amperage loss in long runs like DC suffers from. DC output requires heavy expensive cable and has a high power loss over long runs. (the wind turbines shown above and below COME UNPAINTED) 

Note: If you are replacing a DC output wind turbine with our 3 phase turbine and do not want to change your DC wiring then you can mount the bridge rectifier at the top of the tower for a DC run down. 

The turbine comes with:

Renegade Super Dual PMA with 28 magnet rotor and dual stator. Some specifics: This is our newest PMA, the Renagade Super Dual 2,800 Watt Plus Permanent 28 Magnet Alternator: 24/48, and 48/96 Volt models available. Please choose wind turbine voltage before checkout. Example: If you have a 24 volt battery bank choose the 24/48 volt model.

These are our highest amp models for wind turbine applications. It has our 28 N45 magnet dual rotor dual stator inside and comes with 2 rectifiers. Features a heavy duty stainless steel middle section and heavy duty bearings. Produce more power in extremely low winds or double the voltage output easily from 24 to 48v, or 48 to 96 volt. This is a very versatile permanent magnet alternator. 

Turbine also includes:

Mounting Bracket and Heavy Duty 2 arms tail assembly.

Tail fin: measures 9" wide x 28" tall for maximum tracking wind.

11 nylon and carbon fiber composite blades - Aerodynamically tapered 4 Blades for maximum output.

Steel blade hub is 1/4" thick x 9" in diameter

Mounting Bracket Fits on 1.5" schedule #40 or #80 pipe.

Heavy duty Hub spacer/stabilizer

Two 3 phase to DC bridge rectifiers

Specifications:

11 blade Turbine weighs 21kg

Blades Make 62 1/2" dia.

125,000 hours + of rated bearing life.

RENEGADE SUPER DUAL PMA has no brushes, very dependable!

 
FOR EXTREME LOW WIND CONDITIONS: Blades begin to spin at ONLY 7 MPH - Wind Zone 1 - and begin making power immediately!